Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations 3DDave on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

control value of Length/height ratio

Status
Not open for further replies.
shahpar_imported

shahpar_imported

Mechanical
Mar 20, 2005
1
I want to model a rod for singularity analysis with a thickness jump. I was wondering, if someone can post the control value of Length/height ration of an infinitely long rectangular bar.
 
Status
Not open for further replies.

Similar threads

C
  • Question
Controlling planetary ratio by braking sun gear
Replies
5
Views
2K
mfgenggear
mfgenggear
Henrique Orlandini
  • Question
Interpretation of bolt threaded and unthreaded length for Member Stiffness calculation
Replies
6
Views
2K
Henrique Orlandini
Henrique Orlandini
Channo
  • Locked
  • Question
Thread Engagement length in Fluid power ports 1
Replies
4
Views
1K
ghostdigital
ghostdigital
Channo
  • Locked
  • Question
Bolt Design (Length Of Engagement) 2
Replies
8
Views
712
hydtools
hydtools
Ahmed Elarbagi
  • Locked
  • Question
Horizontal Direct Fired Heater Minimum Stack Height Requirements
Replies
3
Views
448
shvet
shvet

Part and Inventory Search

Sponsor

Back
Top Bottom