AhmedDeiaa
Mechanical
HI, if I have a bolt and I want to disassemble it with a clockwise motion (i.e. continuous Rotating during disassembly) but in assembly sequence not in motion simulation. What should I do?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
continuous Rotating during disassembly
- Thread starter AhmedDeiaa
- Start date
- Status
- Thread starter
- #2
AhmedDeiaa
Mechanical
HI, if I have a bolt and I want to disassemble it with a clockwise motion (i.e. continuous Rotating during disassembly) using NX 9 but in assembly sequence not in motion simulation. What should I do ?
JohnRBaker
Mechanical
There is no way to simultaneously rotate and translate a single part using Assembly Sequencing assigned motions. You can either translate or rotate a single item but not both at once.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
Similar threads
