nabilishes
Mechanical
- Jan 23, 2011
- 15
Hi,
For Abaqus Standard, when defining *CONTACT PAIR (SMALL SLIDING), if both options ADJUST=0.0 and *CLEARANCE,VALUE=0.01 is enabled, does this create strain free adjust of the surfaces to 0 so that it will be in contact and then create the clearance gap for 0.01 OR will it choose either one option only?
For Abaqus Standard, when defining *CONTACT PAIR (SMALL SLIDING), if both options ADJUST=0.0 and *CLEARANCE,VALUE=0.01 is enabled, does this create strain free adjust of the surfaces to 0 so that it will be in contact and then create the clearance gap for 0.01 OR will it choose either one option only?