Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

contact element on 2d beam3

Status
Not open for further replies.
speee

speee

Mechanical
Joined
Feb 14, 2007
Messages
2
Location
US
Can contac171 attached on Beam3 element? i tried but two beam of beam3 pass each other, seems contact element doesn't work...any one can help with this? high appreciated if any examples? (or contact element only work on 3d beam like beam188)?
 
Status
Not open for further replies.

Similar threads

T
  • Question Question
Accessing Named Selections of Contact Surfaces via CMSEL After Applying Condensed Geometry Not Possible
Replies
0
Views
5K
TOM1345
T
nashki
  • Locked
  • Question Question
UDL on the Curve of Elbow
Replies
0
Views
3K
nashki
nashki
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
815
Rabea-19
R
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
andradesilva
  • Locked
  • Question Question
How to change element type in ANSYS Workbench 2023 R1
Replies
1
Views
2K
SPDL310
SPDL310

Part and Inventory Search

Sponsor

Back
Top