Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Consolidate the commands in NX

Thread starter NXsupport
Start date Nov 18, 2019

Status: Not open for further replies.

Nov 18, 2019

NXsupport

Computer

Hi,

NX1872.

I think Siemens should consolidate Fill Surface, N sided surface and Fill Hole commands into one command. That would be much easier. Basically they are multiple ways to fill the gap or build a surface to fill void.

Share your thoughts.