Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Compressor requirements for star-up air

Status
Not open for further replies.

jeap

Chemical
Nov 1, 2006
36
Hi All!

Any one know what is a typical flowrate for start-up air in a reciprocant compressor for natural gas?

and what this air is used for?

Thanks in advance.





 
Replies continue below

Recommended for you

I'll make a leap of faith here. The air is used to drive an air motor that turns the engine to start the engine. On older intergal compressor engine sets the air was injected into the power cylinders with the fuel shut off in a sequencial manner to again get the engin turning so it would start.
 
De Ja Vu all over again. This is the same way thread1036-169995 started. Why don't we confine answers to there.

David
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor