Hi All,
Not very sure this is the correct forum to post this query, but this is a job which is related composite material engineering/manufacturing. Do advise if there is a more appropriate forum to post this.
I'm using the Gerber CutWorks version 9.0 to nest a set of flat patterns in a material roll with a width of 64 inches. But the material settings does not allow me to change the setting greater than 59.0 inch (please see pictures linked below).
I have tried to Google for the location of the setting to disable the limit but to no avail.
Would like to seek advice from anyone who is familiar and provide guidance.
Thanks in advance.
Vincent
Not very sure this is the correct forum to post this query, but this is a job which is related composite material engineering/manufacturing. Do advise if there is a more appropriate forum to post this.
I'm using the Gerber CutWorks version 9.0 to nest a set of flat patterns in a material roll with a width of 64 inches. But the material settings does not allow me to change the setting greater than 59.0 inch (please see pictures linked below).
I have tried to Google for the location of the setting to disable the limit but to no avail.
Would like to seek advice from anyone who is familiar and provide guidance.
Thanks in advance.
Vincent