What would be a good way to composite coat SS piping to efectively make it more corrossive reistance and waht are the right materials for this application. We intend to use 316 ss piping and have some concernse about corrosion if buried by itself witout protection. Any sugestios welcomed.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Composite coating for SS to be buried underground
- Thread starter mb1105
- Start date
Without knowing exactly what you are doing, there are heat shrink/hot melt products that are available. Basically you slide the heat shrink tube over the part and warm it up with a hot air gun. The sleeve shrinks and inside the sleeve is hot melt glue which melts at the same time and totally encapsulates the part; usually this system is to permanently protect high voltage buried electric cable.
- Status
Similar threads
- Locked
- Question
