Component tis non-geometric after adding component in NX-6

[ashivu123]

Sometimes I face this issue when adding the component to the assembly nothing is showing up in the preview window. I checked all the layers setting and reference set of the component being to be added everything is fine, still the issue is same. I added the component absolute origin it was blank in assembly navigator the component is like in hidden shape not a solid one. In component properties (using RMB on component) Checked-off the “Component is Non-Geometric” than the component is visible to position.
Does anyone know how to remove “Component is Non-Geometric” before adding to the assembly?

 

[cowski]

A few threads that may interest you:
thread561-309958
thread561-360113

www.nxjournaling.com

 

[ashivu123]

Thank you very much Cowski,

I have changed DB_PART_UNIT type from IN to each and it worked well issue is resolved.