Feb 6, 2009 #1 TheMan51 Automotive Feb 8, 2007 109 I am a new user of UGS NX5. How would I go about putting the company drawing borders into the system for selection when I start a drawing. Thanks
I am a new user of UGS NX5. How would I go about putting the company drawing borders into the system for selection when I start a drawing. Thanks
Feb 6, 2009 #2 JohnRBaker Mechanical Jun 1, 2006 37,198 This topic has been discussed several times over the last 6 months or so. I suggest that you start by reviewing the posts in the following threads: http://www.eng-tips.com/viewthread.cfm?qid=224860&page=1 http://www.eng-tips.com/viewthread.cfm?qid=228567&page=1 http://www.eng-tips.com/viewthread.cfm?qid=208131&page=1 This should help to get you started. John R. Baker, P.E. Product 'Evangelist' Product Design Solutions Siemens PLM Software Inc. Cypress, CA http://www.siemens.com/plmhttp://www.plmworld.org/museum/ To an Engineer, the glass is twice as big as it needs to be. Upvote 0 Downvote
This topic has been discussed several times over the last 6 months or so. I suggest that you start by reviewing the posts in the following threads: http://www.eng-tips.com/viewthread.cfm?qid=224860&page=1 http://www.eng-tips.com/viewthread.cfm?qid=228567&page=1 http://www.eng-tips.com/viewthread.cfm?qid=208131&page=1 This should help to get you started. John R. Baker, P.E. Product 'Evangelist' Product Design Solutions Siemens PLM Software Inc. Cypress, CA http://www.siemens.com/plmhttp://www.plmworld.org/museum/ To an Engineer, the glass is twice as big as it needs to be.
