come together

koyote5 · Dec 11, 2004

i have two parts that compliment each other, in that one of them is in a sence the area missing from the other. If I was creating a part i could use the combine feature to subtract one area from the other. In the assembly however i am having difficulty doing this since it is two distinct parts. Any ideas?

aamoroso · Dec 11, 2004

Cavity? Look it up in Help.

CorBlimeyLimey · Dec 11, 2004

In SW04 & up, you could use the multi-body feature. Insert one part into another part, position the inserted part where needed, then use the combine-subtract function.

[cheers]