Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

cold runner system for injection presses

Status
Not open for further replies.
captam21

captam21

Mechanical
Joined
Sep 16, 2003
Messages
2
Location
US
I am trying to justify to management any real cost benefit in purchasing a cold runner system for or presses ,I am trying to find a formula to show them a cost savings ,the material used will be a conductive hydrin...thanks
 
Status
Not open for further replies.

Similar threads

ivyliu
  • Locked
  • Question Question
Post curing for LSR
Replies
1
Views
866
Compositepro
Compositepro
Mark M
  • Locked
  • Question Question
Minimum cavity pressure for rubber molding
Replies
0
Views
681
Mark M
Mark M
scott1971
  • Locked
  • Question Question
Origins of "FPM" and "FFPM" for fluoroelastomer and perfluoroelastomer?
Replies
0
Views
668
scott1971
scott1971
Gautham_26
  • Locked
  • Question Question
frequent nozzle block in injection molding
Replies
2
Views
301
btrueblood
btrueblood
Garrett Green
  • Locked
  • Question Question
Shore A Hardness for sealing
Replies
9
Views
797
Tmoose
Tmoose

Part and Inventory Search

Sponsor

Back
Top