coolniks37
Mechanical
- Feb 7, 2013
- 85
Hi
I need to analyse boiler header (ASME Sec I design) in ANSYS.
It is supported by means of 2 CLHs, using U rods, at some 1.1m span.
I have now modelled the header geometry. How do I give the condition of CLH support in ANSYS?
I am getting wrong results if I give the load at the points?
Kindly help.
Anyone has any help/support files for this.
I need to analyse boiler header (ASME Sec I design) in ANSYS.
It is supported by means of 2 CLHs, using U rods, at some 1.1m span.
I have now modelled the header geometry. How do I give the condition of CLH support in ANSYS?
I am getting wrong results if I give the load at the points?
Kindly help.
Anyone has any help/support files for this.
