Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cleaning for Chlorine Service

Status
Not open for further replies.
meister

meister

Chemical
Joined
Nov 20, 2001
Messages
19
Location
US
Does anyone have a good, simple procedure for preparing new equipment for chlorine service (heat exchanger, piping)? I know that all the debris, oils, etc from fabrication must come off, but what is the easiest way to do this? Thanks!
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

LS_SMS
  • Question Question
Can Service Pressure Exceed Design Pressure?
Replies
13
Views
26K
LittleInch
LittleInch
AspenMech
  • Locked
  • Question Question
Inconel overlay for tubesheet in hydrogen service
Replies
6
Views
2K
weldstan
weldstan
Whin
  • Question Question
Heat Exchanger one stream out of service
Replies
3
Views
585
LittleInch
LittleInch
KD007
  • Question Question
SA-193 Gr.B7M bolt material used in Wet H2S service is not passing requirement of UG44b clause.
2
Replies
20
Views
10K
r6155
r6155
J
  • Question Question
Vessel for Hydrotest over MAWP
Replies
7
Views
15K
Trestala
Trestala

Part and Inventory Search

Sponsor

Back
Top