Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Clamping force of a collar(cut into 3 pieces)

Status
Not open for further replies.
josevski

josevski

Mechanical
Jun 11, 2013
5
If I have a collar(cut into 3 pieces) that I have to clamp to a shaft using 3X 14mm zinc plated high tensile bolts (14.9 grade), what will
be the clamping force of the collar to the shaft(assuming preload of each bolt is 86 kN)?
 
Status
Not open for further replies.

Similar threads

BasakAbhishek
  • Locked
  • Question
Estimation of torque in stuffing box of pumps
Replies
5
Views
3K
BasakAbhishek
BasakAbhishek
BasakAbhishek
  • Question
Sealing of gases by lip type seal
Replies
7
Views
4K
SB1976
SB1976
moon161
  • Locked
  • Question
Dry gas instead of liquid for leak test in pump w/ mech seal.
Replies
4
Views
2K
A8yssUK
A8yssUK
MechyMarco
  • Locked
  • Question
PEEK Piston Cap Instead of PTFE?
Replies
0
Views
194
MechyMarco
MechyMarco
Ram RJSRG
  • Locked
  • Question
Hi Engineers, I have a small quest
Replies
2
Views
878
satthepbienhoa
satthepbienhoa

Part and Inventory Search

Sponsor

Back
Top Bottom