Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Chipping hammer on edge of beam and slab

Status
Not open for further replies.
itez

itez

Structural
Joined
May 5, 2013
Messages
52
Location
PH

What happens if you use chipping hammer on edge of beam and slab to make a hole in the slab to fully wrap around the beam a carbon fiber sheet? Would chip hammering the edge damage the beam? For those who have used chipping hammer before, what do you think?
 
Status
Not open for further replies.

Similar threads

Brad805
  • Question Question
Thickened Edge Slab Analysis
Replies
6
Views
2K
Flotsam7018
Flotsam7018
B
  • Question Question
Slab-on-ground: EDGE THICKENING VS SHRINKAGE RESTRAINT
Replies
2
Views
2K
GJoeRMK
GJoeRMK
just_some_shmuck
  • Locked
  • Question Question
I-beam edge radii
Replies
4
Views
4K
HTURKAK
HTURKAK
S
  • Question Question
Slab on Grade
Replies
2
Views
7K
g.n
g.n
strucbells
  • Question Question
exterior slab on grade
Replies
3
Views
7K
JAE
JAE

Part and Inventory Search

Sponsor

Back
Top