Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Charted Drawing Concept in NX 1
- Thread starter CAD2015
- Start date
-
1
- #2
Depends on how you want to set them up and use them.
We used to do a single sheet drawing with 3 columns in a table for the charted information. Each row contained our part number, the cocor and the OEM part number. We had a generic model for the 'standard' part since we were only chnaging colors for the other part numbers.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
We used to do a single sheet drawing with 3 columns in a table for the charted information. Each row contained our part number, the cocor and the OEM part number. We had a generic model for the 'standard' part since we were only chnaging colors for the other part numbers.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
- Thread starter
- #3
My experience was pretty similar to Ben's, but the chart showing the differences was usually only based on paint color changes (Part number A was painted with color number 1 for example). When geometry differed, such as for a chrome plated part, there was a new model added and views on the drawing displayed and called out the geometry difference for those specific part numbers only.
Tim Flater
NX Designer
NX 8.0.3.4
Win7 Pro x64 SP1
Intel Xeon 2.53 GHz 6GB RAM
NVIDIA Quadro 4000 2GB
Tim Flater
NX Designer
NX 8.0.3.4
Win7 Pro x64 SP1
Intel Xeon 2.53 GHz 6GB RAM
NVIDIA Quadro 4000 2GB
- Status
