Changing weldment properties

[Brett04]

I am very new to SW and am trying to draw a part that uses .75 x .75 x .125 steel square tube. I do not see it listed and would like to add it to the list. What is the best and/or easiest way to do this? Thanks!

Brett

 

[SBaugh]

Make a new sketch and add it to your Weldment profiles.

The path would be something like this - C:\Program Files\SolidWorks04\data\weldment profiles\ansi inch\square tube

You can make a new folder if you need too under "Weldment Profiles"

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376