Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing Se part default sizes

Status
Not open for further replies.
freake

freake

Industrial
Aug 25, 2007
1
Is there any way to change SE V20 - default sizes - for example radii set at r5 changed to r2 or switch of preview generated.
 
Status
Not open for further replies.

Similar threads

J
  • Locked
  • Question
VBA to Pull Total Surface Area and Volume for a Part of an Assembly?
Replies
0
Views
1K
jdconnel
J
NirVidP
  • Locked
  • Question
How to 'Create Part In Place' using vba?
Replies
0
Views
887
NirVidP
NirVidP
Danu88
  • Locked
  • Question
[HELP] Part quantity on single part drawing
Replies
4
Views
514
Danu88
Danu88
QuentinMoran
  • Locked
  • Question
3rd Party dft Viewer
Replies
1
Views
1K
matnas
matnas
blitz97
  • Locked
  • Question
ST10 Part Family Table
Replies
1
Views
252
blitz97
blitz97

Part and Inventory Search

Sponsor

Back
Top Bottom