GiantIsopod
Mechanical
- Jun 24, 2025
- 8
Hi All,
I am curious if anyone knows how to drive changes in a model from a drawing?
I know that the opposite is possible-- I change a model, update the drawing, and I'm all set.
However, suppose I want to drive model changes from a change I make in the drawing.
If I have a box that is 12 inches long in a drawing, is there a way such that if I change that length to 14 inches, then the model will update based on that?
Apologies if my question is hard to understand. I am trying to make the model accommodate the drawing instead of the other way around.
I am curious if anyone knows how to drive changes in a model from a drawing?
I know that the opposite is possible-- I change a model, update the drawing, and I'm all set.
However, suppose I want to drive model changes from a change I make in the drawing.
If I have a box that is 12 inches long in a drawing, is there a way such that if I change that length to 14 inches, then the model will update based on that?
Apologies if my question is hard to understand. I am trying to make the model accommodate the drawing instead of the other way around.
