Changing mdl dims from a table in drawing

[Ákos Matyus]

Hi!

I want to modify my model dims, from a table what i created in a drawing. I have lot of parameters and I want them to be in one table, and in that table I want to modify the parameter values. After created the table with repeat region in the drawing, and found the proper options i couldn't modify backwards the values in the table.
Is it possible to do such a thing in creo?

 

[per2fh]

My understanding...
the repeat region in a drawing is a "read from the model". It can be programmed to adjust the data pulled (read) from the model but it can not push it.

It sounds like a family table is in your future.

 

[dross]

A layout will do what you want but that being said, I do have a table that has the dims from the model that I can change and the model will change with two regenerations, but it is not a repeat region.