Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Change hole call out precision
- Thread starter tinhman
- Start date
What do you mean - change the number of decimal places?
I vaguely recall this is one place where SE falls down a little and it's a one size fits all global setting or something but my memory aint what it was.
I vaguely recall this is one place where SE falls down a little and it's a one size fits all global setting or something but my memory aint what it was.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Thread starter
- #3
Woodyscolts
Mechanical
Click on the dimension you want to change and near the top a ribbon bar will show a number of things. /the second box from the left should be the precision where you can change to 2 places and second from the right side of the ribbon bar is an X, you can click on that and add a tolerance note.
Woodyscolts
Mechanical
oops gues I should have looked closer, you wanted it for hole callout. Sorry
- Status
Similar threads
- Locked
- Helpful tip