I am in the process of using Geopak to help obtain beam offsets for a bridge. My question, is there a way to store and print the length of these offsets in order to have a printout at several locations? Does this require the use of the chain command? If so, how do I begin to set this up? I an new to Geopak, and no one at the office seems to know a way to produce the information for printout. Thank you in advance for your help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Chain Command
- Thread starter DJYork
- Start date