Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Centerlines & Center Mark Hidden

Status
Not open for further replies.
Drhinehart

Drhinehart

Mechanical
Apr 21, 2004
64
Ok this was just persented to me and I can't figure it out.

You manually put a center mark or a center line into a drawing. Then you right click the centerline or center mark and selct hide...How do you unhide these annotations?

The centerline has to be put in thru the annotations menu.


SW2005 SP02
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Nevermind found the solution by hitting the hide/show command on the annotations toolbar...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

fcsuper
  • Locked
  • Question
What's the standard that specifies the size of center marks and when they should be added to holes?
Replies
6
Views
423
TheTick
TheTick
v5newto
  • Locked
  • Question
See hidden elements
Replies
1
Views
168
SBaugh
SBaugh
Sa-Ro
  • Locked
  • Question
Hidden dimension 1
Replies
16
Views
465
Jboggs
Jboggs
borsht
  • Locked
  • Question
ordinate dimension to center of forshortened radius center. How can I do this 1
Replies
12
Views
845
SBaugh
SBaugh
Sa-Ro
  • Locked
  • Question
Mark up tool in model or drawing 1
Replies
2
Views
167
Sa-Ro
Sa-Ro

Part and Inventory Search

Sponsor

Back
Top Bottom