Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

center of gravity

  • Thread starter Thread starter sagrob
  • Start date Start date
S

sagrob

Guest
Hi All!


How can Imeasure the center of gravity in a sketch. The sketch is a spline.





Thanks!
 
Sweep and circular cross section along the spline to create a solid (the center of the circle must be on the spline). Then calculate the mass properties to get the CG.
 
You must log in or register to reply here.

Similar threads

S
Dynamic Analysis of Theo Jansen walking mechanism
Replies
0
Views
37K
Sai Rakesh
S
B
How to create Rigid links using Center of gravity and Moments of Interia in Ansys WB?
Replies
0
Views
4K
Bruce321
B
V
How to properly set up the limits of a simulation?
Replies
0
Views
7K
Villa
V
R
Status of MDO
Replies
0
Views
3K
rework
R
H
Can ProE simulate mechanics of materials book's question?
Replies
2
Views
3K
Fatiguester_FA
F

Part and Inventory Search

Sponsor

Back
Top