PowerRanger
Structural
- Jan 17, 2005
- 60
Hi Fellows
A question about the panel bearing. From page 30, it said the panel should be supported at one level by two (no more, no less) seatings in direct beating. But in page 10, the Figure 3 showed 3 piers support the panel.
Did I miss understand something?
Also, do any one know any good books for bridge design according to AS 5100 -2004.
Thank you for your time.
A question about the panel bearing. From page 30, it said the panel should be supported at one level by two (no more, no less) seatings in direct beating. But in page 10, the Figure 3 showed 3 piers support the panel.
Did I miss understand something?
Also, do any one know any good books for bridge design according to AS 5100 -2004.
Thank you for your time.
