in the design of pressure vessels, ASME Section VIII indicates that casting quality factors are to be taken into consideration. can somebody explain what these factors are and in what instances these factors are to be used.should these be considered in designing bolted joints particularly on allowable stresses ?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Casting Quality Factor
- Thread starter manian
- Start date
Similar threads
- Locked
- Question
- Locked
- Question