Capital Essentials............................ 3

[CAD2015]

Hi,
Does somebody use the Capital Essentials?
Is it a 2D (only) software?

Thanks,

 

[Gr8blu]

See corporate "blurb" at following link.
My take is that Capital Essentials is strictly 2D, with the ability to interact with 3D models.
https://static.sw.cdn.siemens.com/s.../Siemens SW Capital Essentials Fact Sheet.pdf

 

[CAD2015]

Gr8blu:

Thanks a lot!

 

[IRstuff]

The glossy brochure cited above seems to imply some sort of 3D capability

Integration with 3D CAD systems–model in 3D and engineer the electrical detail with Capital Essentials

https://www.cadlog.com/download/int...41S3YomGWISrXyFFwTS-QASdz7K2RDodoP37iHOK2nFcw says that MEs can use the harness design to get accurate 3D lengths and layouts.

 

[CAD2015]

IRstuff,​

Your link can't be opened.....

 

[3DDave]

Alternate: https://trias-mikro.de/wp-content/u...echanical-wire-harness-design-White-Paper.pdf

Also a little insight into Siemens for their locking of copy/search on their marketing materials.

 

[IRstuff]

Try this https://www.cadlog.com/electrical-system-design/vesys/ download link near bottom of page