Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

capacitance and resistance

Status
Not open for further replies.
Replies continue below

Recommended for you

The equation is of the same form as it is with pure resistances in either position. You simply substitute the impedance representation of the capacitor for the affected resistance and simplify

TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
 
Until you introduce at least some change in potential across the capacitor and only during the time of the changing potential, the impedance of a perfect capacitor is infinite.
Formula for static conditions may not be valid for dynamic conditions.


--------------------
Ohm's law
Not just a good idea;
It's the LAW!
 
OP's drawing is a feedback op amp, so the instructor's expectation should be pretty clear; they're looking for an active filter equation. Additionally, the lower case notation of input and output would likewise imply a small-signal representation.

TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
 
for op - assuming an ideal op amp, what do you think would be the voltage at the negative input terminal for the op-amp? How about the current into that terminal?

=====================================
(2B)+(2B)' ?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor