Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cantilever vs. three point bend DMA.

Status
Not open for further replies.
RPstress

RPstress

Aerospace
Joined
Jun 4, 2003
Messages
846
Location
GB
Does anyone have opinions about the relative merits of these two specimen/test configurations?

I believe three point bend is more sensitive, but does it have any drawbacks?
 
Status
Not open for further replies.

Similar threads

vinguy
  • Locked
  • Question Question
Compressed Air vs Nitrogen for Autoclave Cures
Replies
5
Views
2K
georgeverghese
georgeverghese
midsidenode
  • Locked
  • Question Question
Film Adhesive - Supported vs Unsupported
Replies
3
Views
1K
SWComposites
SWComposites
dcascap
  • Locked
  • Question Question
Insert bending test
Replies
5
Views
973
Compositepro
Compositepro
Ryan_aero
  • Locked
  • Question Question
Tensile vs. Compressive Modulus % Difference
Replies
4
Views
1K
Compositepro
Compositepro
glass99
  • Locked
  • Question Question
Heated mold vs oven vs autoclave
Replies
4
Views
968
thebard3
thebard3

Part and Inventory Search

Sponsor

Back
Top