Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can't display whole model

Status
Not open for further replies.

scottneh

New member
Joined
Jun 15, 2010
Messages
4
Hello, I have been working with NX/UG for a while and have noticed an issue displaying large models but can't seem to figure out what is going on. I'm currently working with a model that is 9 feet long and 6" in diameter. When I rotate the model into certain directions it gets cutoff as if there is a bounding box or something. If I zoom in on that area it still remains cutoff. Anyone seen this before or know how to resolve it?

Thanks
Scott
 
Go to...

View -> Camera -> Edit...

...and near the bottom of the dialog, push the button titled 'Fit Planes to Extents' and then hit OK. Your display should now be OK.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Or click Fit command. It will also fix this display issue.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top