Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cannot make coincident constraint

  • Thread starter Thread starter Karol
  • Start date Start date
K

Karol

Guest
The circle isn't fully constrained.
I want to add a coincident constraint in the center of the
circle, with the end of the line, but when i select the
point there isn't such a constraint available.
<a target="_blank" href="uploads/Karol/2012-09-22_132354_Drum.zip" target="_blank">2012-09-
22_132354_Drum.zip</a>
 
You must select both points (the center of the circle and the end of line, using CTRL) then the constrain will be available.



Edited by: Mihail
 
The center of the circle was constrained by the dimension(138.75mm).
 

Part and Inventory Search

Sponsor

Back
Top