can I push pull geometry in NX modelling

[helperug]

No idea, can nx push geometry with geometry.
Example: moving a block untill it stopps at clash or pick body of collision an move both?

sorry new in NX
regards
Erwin

 

[JohnRBaker]

Well, there is a 'Clash Detection' option when running a 'Sequence' of an Assembly, but there is no automatic 'two bodies becoming one' for purposes of simulating one body 'pushing' another. Perhaps as part of some of the analysis routines which uses 'physics' when doing a simulation.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[cowski]

In an assembly, the "move component" command has options for collision detection. But I know of no way to move a component when something collides with it.

www.nxjournaling.com

 

[Toost]

You can do this in the motion simulation.
Regards,
Tomas

 

[helperug]

Oh I have seen in NX Concept designer, I remember.
... the nice to haves in basic design
regards


sorry new in NX
regards
Erwin