M
McGloughlin
Guest
Hello,
I am trying to find a CAM programmes to work along with solidworks, where is good to research what programme would be good, probably looking for a basic programme initially until I get to grips with using it. I have read a little on bobcam, dolphincam and meshcam as good starter programmes, its to go with a hurko hawk 5m.
I have been scrolling through the web but finding it hard to get detailed descriptions on packages like these, no doubt I am just looking in the wrong places. I am based in Galway, Ireland so would be interested in some European support.
Any advice appreciated.
Thanks.
I am trying to find a CAM programmes to work along with solidworks, where is good to research what programme would be good, probably looking for a basic programme initially until I get to grips with using it. I have read a little on bobcam, dolphincam and meshcam as good starter programmes, its to go with a hurko hawk 5m.
I have been scrolling through the web but finding it hard to get detailed descriptions on packages like these, no doubt I am just looking in the wrong places. I am based in Galway, Ireland so would be interested in some European support.
Any advice appreciated.
Thanks.
Last edited:
