alindragan
Mechanical
Because are still many company that used ± tolerances I have few questions regarding inspection of these according to ISO standards/independence principle.
I know that size dimension is the distance between two points, like a measurement done with a caliper.
The questions are:
1.How many measurements with the caliber shall I do to a part in order to qualify the part as a good part.
2.How do I know to choose the good direction of the measurements? In attachment I have a part with two measurement can I classify this part as a good part?
3.Do anyone any know any standard or documentation that explains this?
I know that size dimension is the distance between two points, like a measurement done with a caliper.
The questions are:
1.How many measurements with the caliber shall I do to a part in order to qualify the part as a good part.
2.How do I know to choose the good direction of the measurements? In attachment I have a part with two measurement can I classify this part as a good part?
3.Do anyone any know any standard or documentation that explains this?
