CADLink / Profile Lab - Flat Bed Profile Gas Cutting

[Milkboy]

In looking for a program to covert a dxf or similar into NC as per CADLink and ProfileLab.

THe programs I have found so far are FAR to advanced for what I need
I am cutting profiles on Fork Lift Truck Forks in 1 offs
and no need for nesting or similar

Any advice appreciated



-
Milkboy

 

[AJUK]

As a structural engineer, I know nothing of this subject but have you tried TurboCADCAM

http://www.imsisoft.com/prodinfo.asp?t=1&mcid=152

I hope that's the sort of thing you need.