I would like to know as is the calculation of buckling of a shank. I have a doubt, I do not know if I should make a single piece and apply a compressive force on the rod or if I have to do two pieces, and apply internal pressure. Thank you very much for everything.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Buckling calculation hydraulic cylinder
- Thread starter Patzun
- Start date
Similar threads
- Locked
- Question