Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bronze Impellers Repair
- Thread starter LucasVrV
- Start date
Before you go too far, I would strongly suggest you review the attached
- Thread starter
- #4
Metengr -
Weld Repair
Material of the impeller: Nickel Aluminum Bronze (ASTM M148 C95800)
Pic
Thank you!
Weld Repair
Material of the impeller: Nickel Aluminum Bronze (ASTM M148 C95800)
Pic
Thank you!
Ok, I think the attached link should provide the necessary information to guide you along;
- Thread starter
- #6
EdStainless
Materials
Why are you repairing these?
Unless there were gross defects in the originals the repaired ones will have poorer performance (corrosion and fatigue).
Maybe you need to look at the service and the original design.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
Unless there were gross defects in the originals the repaired ones will have poorer performance (corrosion and fatigue).
Maybe you need to look at the service and the original design.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
- Thread starter
- #8
EdStainless
It is just a temporary repair, until the new ones arrive (maybe 3 months until arrive)
The defects are some cracks in it like the photo in att.
It is just a temporary repair, until the new ones arrive (maybe 3 months until arrive)
The defects are some cracks in it like the photo in att.
- Status
Similar threads
