Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bronze bearings
- Thread starter rguil
- Start date
Yes-
I do.
Ken
Machine the journal until it true again, remove minimal amount of material to accomplish this, make a new bronze sleeve bushing to fit the new shaft with the proper clearance. Usually .001" per inch of shaft diameter is the clearance.
I do.
Ken
Machine the journal until it true again, remove minimal amount of material to accomplish this, make a new bronze sleeve bushing to fit the new shaft with the proper clearance. Usually .001" per inch of shaft diameter is the clearance.
- Status
Similar threads
- Locked
- Question