Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Breaking References in SW Explorer

Thread starter Prototrax
Start date Apr 19, 2007

Status: Not open for further replies.

Apr 19, 2007

Prototrax

Mechanical

Using SW 2006 Explorer at my old job, I was able to re-use assemblies and rename them in SW Explorer. This would also break all the external references.
Now using SW Explorer 2007, I copied an assembly ( an assembly I have stored in my Library) to a new folder and went to rename the files in it. The old references are still there. If I change the assembly in some way the library assembly also changes/ updates.

Am I not clicking on something?