Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Break-out Section View in NX 8.5
- Thread starter pjune
- Start date
JohnRBaker
Mechanical
Have you found the command yet? If not, go to...
Insert -> View -> Section -> Break-out...
...and once the dialog is opem press the 'F1' key and the NX Help page will open for this function and it will show you the steps that you need to do to create a 'Break-Out' section view. On the righthand side of the NX Help page there are links to some additional items some of which include step-by-step examples with illustrations.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
Insert -> View -> Section -> Break-out...
...and once the dialog is opem press the 'F1' key and the NX Help page will open for this function and it will show you the steps that you need to do to create a 'Break-Out' section view. On the righthand side of the NX Help page there are links to some additional items some of which include step-by-step examples with illustrations.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
