Are there any special considerations when brazing naval bronze. I have a cracked propeller strut, lengthwise along the bearing tube length [bottom] and would like to braze it in place. The tube holds a 2"x 5" cutlass bearing for an 1 1/4" shaft. Brazing is the best option as removing strut is a much more complicated process.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
brazing Naval bronze
- Thread starter windpower
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
