Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bottom Plates - Minimum Width

Thread starter TerryThompson
Start date Mar 27, 2003

Status: Not open for further replies.

Mar 27, 2003

TerryThompson

Petroleum

Clause 3.4.1 in API 650 states that sketch plates shall have a minimum nominal width of 72 inches. Usually on a floor plate layout there are 4 pieces that are "pie" shaped. Does this mean that one or both sides of this "pie" must be at least 6 feet from the lap to the shell?
Thanks
Terry