Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
BOM templates
- Thread starter chopper75
- Start date
From the NX help:
Set the default parts list template to your custom parts list template:
1.Make sure to note the location of your custom parts list template file.
2.Choose File→Utilities→Customer Defaults.
3.Choose Drafting→Annotation, then select the Parts Lists tab.
4.Do one of the following:
◦For native NX mode, type the file name of your custom parts list template, and path of your file if it is not in the UGII_TABLE_TEMPLATES directory, in the Default Parts List: Native mode box.
Example
my_template.prt
Example
D:/templates/my_template.prt
*For managed NX mode, type @DB/ then the file name and revision of your custom parts list template in the Default Parts List: TCIN mode box.
Example
@DB/my_template/A
5.Click OK to save the changes and close the dialog box.
6.You must exit and restart NX to set the default for all NX sessions.
7.(Optional) Open a part and add a parts list using Insert→Table→Parts List.
Notice that the parts list is presented in the format given by your custom parts list template.
Set the default parts list template to your custom parts list template:
1.Make sure to note the location of your custom parts list template file.
2.Choose File→Utilities→Customer Defaults.
3.Choose Drafting→Annotation, then select the Parts Lists tab.
4.Do one of the following:
◦For native NX mode, type the file name of your custom parts list template, and path of your file if it is not in the UGII_TABLE_TEMPLATES directory, in the Default Parts List: Native mode box.
Example
my_template.prt
Example
D:/templates/my_template.prt
*For managed NX mode, type @DB/ then the file name and revision of your custom parts list template in the Default Parts List: TCIN mode box.
Example
@DB/my_template/A
5.Click OK to save the changes and close the dialog box.
6.You must exit and restart NX to set the default for all NX sessions.
7.(Optional) Open a part and add a parts list using Insert→Table→Parts List.
Notice that the parts list is presented in the format given by your custom parts list template.
- Status
Similar threads
- Locked
- Question
