I have an assembly with a family table. The instances are accessories to the main assembly. I created a drawing with the main assembly view and two views that show the accessories. There are (4) .375 nuts used in the main assembly view and (1) .375 nut used in one of the accessory views. I have a BOM set up with 3 repeat regions for the 3 views. My problem is the repeat region for the accessory shows a quantity of (5) .375 nuts. I want to show a quantity of (1) for this accessory view in this repeat region. Can I do this? If so how? TIA for your help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
BOM Quantities
- Thread starter WRH
- Start date
- Status
Similar threads
- Locked
- Question