Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bom balloons not updating

  • Thread starter Thread starter mwikoff
  • Start date Start date
M

mwikoff

Guest
I am currently working in a large assembly with a multi-sheet drawing. I am making a revision to the drawing, and when I add a component that is already in the bill of materials it will add that quantity correctly to the BOM in the drawing, but it doesn't drop the quantity onto a pre-existing balloon or allow me to create a new balloon by any of the methods. The only way I have been able to get them to show up is to delete all the pre-existing balloons and then create the balloons for that component over again. This is ok if it is just a couple parts, but I have one component that has nearly 100 balloons. I also don't want to release this and pass it onto someone else to have this issue in the future. I am working in CREO 2.0.

This drawing was created in Wildfire 4.0.
 
Last edited:

Part and Inventory Search

Sponsor

Back
Top