Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Boiler Controls, Europe and USA

Status
Not open for further replies.

Robster1us

Mechanical
Dec 31, 2009
27
Hello all. I am looking to make sense of implementing EN 12953-9 and EN 12952-11 (they have essentially the same requirements with regard to my application). I am in the US but trying to produce a design that's applicable to both Europe and the USA for my safety systems for a hot water boiler (low pressure as defined in ASME CSD-1).

What I'm finding is that it's very difficult to source limiters in the US that are built and tested in accordance with the EN standards listed above. ASME CSD-1 references UL 353 for requirements for limiting devices, for which I am able to find some limiters (compliance listed in the limiter technical literature). My question is, does anyone know how harmonized UL 353 and EN 12953-9 are? Could I make a case to a European authority that UL 353 limiters meet the 12953-9 requirements?

Any help is greatly appreciated.
 
Replies continue below

Recommended for you

very difficult. programmable controllers can solve the problem.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor