Hello Sakari
Well, all depend on the flow of biogas that you will have for treatment and the percentage of co2, but if it is a significant quantity of biogas, and co2, I am sure you will prefer to use some pressure, maybe a lot.
Other thing is the liquid you wish to use for the treatment, and of course the final use of the biogas.
Flow of biogas is only about 120 liters per minute (small farm size digester)and CO2 content is less than 40% (60 to 65% methane). We are using the purified methane gas as vehicle fuel and it means it should be 97% pure methane!
Liquid used for scrubbing is pure water or water with lime stone (or some other suitable stuff).
You've answered your own question- it's a waste of time. Even large landfill gas energy recovery systems operating with internal combustion engines are using the biogas without attempting to remove the CO2 from the methane. The additional efficiency derived from operating on purified methane doesn't pay the capital and operating costs of CO2 removal even on such a large scale, so on your scale it's hopeless.
Use the methane to fire a heater or something else which doesn't care so much about the CO2 that comes along for the ride.
i believe you only have to use pure water to scrub the gas . we use it to fire our dual burner boilers and its doing great. i will also agree with moltenmetal that its useless to to try scrubbing out the CO2 gas. thanks
i agree with my friend molten metal that its useless to scrub out co2 since we are using methane gas to fire our dual burner boilers after scrubbing through process water.
It is essential to scrubb out CO2 because of limited fuel storage in bi-fuel car. In burners it is not needed I agree. But how to make it cost effective??
Do you need to scrubb?
For small production of biogas the most economical option will be membranes. You can go to a 98% CH4 (Nm3) and you will have a low percentage of water.
