Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Berak-out section view base point ?
- Thread starter skanskan
- Start date
JohnRBaker
Mechanical
Breakout Section views have a 'starting point' and direction. The 'Base Point' is that starting point. If you toggle ON the 'Cut Through Model' option then the point will only be used to help define the origin for the 'extrude' vector but the section cut will go completely through the model. Is you toggle the option OFF, the section cut will only START at that point and then go through only that part of the model in the direction of the 'extrude' vector.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
