Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bending round tubes..

Status
Not open for further replies.
libanais

libanais

Mechanical
Joined
Jul 15, 2004
Messages
10
Location
CA
Is it possible to bend a round tube in .PSM or .par file?

Thnaks:)
 
Sort by date Sort by votes
Not to bend it, no.

But, you can create a tube profile and sweep it around a bent path which would give you the results you're looking for.

--Scott

For some pleasure reading, try FAQ731-376
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

andyke001
  • Locked
  • Question Question
bending parts in solid edge
Replies
11
Views
508
andyke001
andyke001
eatfood
  • Locked
  • Question Question
Proper method of drafting structural frames of welded tubes
Replies
4
Views
459
eatfood
eatfood
VABiker
  • Locked
  • Question Question
Round command - deselect?
Replies
1
Views
407
VABiker
VABiker
jjengel
  • Locked
  • Question Question
Add round with larger radius than cylinder
Replies
4
Views
252
burhop
burhop
westminzer
  • Locked
  • Question Question
bending a "part"
Replies
1
Views
108
donyoung
donyoung

Part and Inventory Search

Sponsor

Back
Top